Student Dashboard

Please disable anti-virus software before installing any software application.

ProSpangle 2026

By /

Course Information

Course Instructor

Matt Bell Matt Bell Author

Intro & Setup

Uncrating
Lesson 1 of 6 within section Intro & Setup. You must enroll in this course to access course content.
Leveling
Lesson 2 of 6 within section Intro & Setup. You must enroll in this course to access course content.
Putting Tapes on Punches
Lesson 3 of 6 within section Intro & Setup. You must enroll in this course to access course content.
Overview of Control Panel
Lesson 4 of 6 within section Intro & Setup. You must enroll in this course to access course content.
Press Unit
Lesson 5 of 6 within section Intro & Setup. You must enroll in this course to access course content.
Removing and Installing a Press Unit
Lesson 6 of 6 within section Intro & Setup. You must enroll in this course to access course content.

Operation

Powering on Machine / Common Errors
Lesson 1 of 12 within section Operation. You must enroll in this course to access course content.
Checking Transfer Sheet Table Movement
Lesson 2 of 12 within section Operation. You must enroll in this course to access course content.
Putting Design into Memory
Lesson 3 of 12 within section Operation. You must enroll in this course to access course content.
Selecting Design To Be Run
Lesson 4 of 12 within section Operation. You must enroll in this course to access course content.
Set The Colors / Assign Press Units (Punches)
Lesson 5 of 12 within section Operation. You must enroll in this course to access course content.
Load Transfer Sheet and Center Table
Lesson 6 of 12 within section Operation. You must enroll in this course to access course content.
Trace the Design
Lesson 7 of 12 within section Operation. You must enroll in this course to access course content.
Run the Design
Lesson 8 of 12 within section Operation. You must enroll in this course to access course content.
Complete Process of Running a Design From Start to Finish
Lesson 9 of 12 within section Operation. You must enroll in this course to access course content.
Deleting Design From Memory
Lesson 10 of 12 within section Operation. You must enroll in this course to access course content.
Pressing the Design to Garment
Lesson 11 of 12 within section Operation. You must enroll in this course to access course content.
Programming an Offset
Lesson 12 of 12 within section Operation. You must enroll in this course to access course content.

Maintenance & Misc.

Daily Maintenance
Lesson 1 of 2 within section Maintenance & Misc.. You must enroll in this course to access course content.
Weekly / Monthly / Yearly Maintenance
Lesson 2 of 2 within section Maintenance & Misc.. You must enroll in this course to access course content.